MC4 Solarline 2 PV-Wire Cables Cat. No. MC4- 4mm MC#10 Weight 1 lbs

Multi-Contact Solarline family of connectors delivers a flexible system solution for time-saving, dependable series-cabling of solar modules.   All module manufactures supply their grid-tie modules with pre-assembled outputcables, tested and ready  for connection.  This saves considerable time during an installation and greatly increases reliability over wire junction boxes.  These cable couplers are fully touch-protected and designed for up to 100 wats and 30 amps.  They are also waterproof.  For parallel connection of modules in 12-to 48-volt systems, Multi-Contact makes branch connectors for use with currents up to 30 amps.  In 2007, PV manufactures began switching to Multi-Contact Solarline 2 locking connectors to meet future electrical code requirements. Multi-Contact plug-andplay connector system allows for the PV arrays to be pre-assembled and pre-wired in the shop or on site.  Proper crimping to the wire and insulator assembly requires special tools. MC4 Solarline 2 PV-Wire Cables:   These cables have the newer, snap-togther Multi-Contact hard plastic conectors on each end and are made with PV-Wire that has an extra layer of installation for use on ungrounded arrays in conjuntion with transformless inverters.  This type of wire is required to meet the 2008 NEC if you are using a transformerless inverter. Model: MC4-795009, Cable length 3 foot : $19.50 MC4-795004, Cable length 10 foot : $30.00 MC4-5795005, Cable length 20 foot : $43.00 MC4-795006, Cable length 30 foot : $62.00 MC4-79500, Cable length 50 foot : $88.50 MC4-795008, Cable length 100 ft : $163.00